Two-brothers-racing Suzuki SV650 Manuel d'utilisateur télécharger pdf (Page 3)

ITBR001-101

2007-09 Suzuki SV650 - 3

Figure AFigure BFigure C

unplug

The ignition must be turned OFF before installation.

1 Remove the main seat and the passenger seat.

2 Prop the front of the fuel tank up using the Suzuki prop rod.

3 Remove the air box.

Note:The air box does not need to be removed to perform this installation, but

removing the air box may make it easier as the stock injector connectors can be very

difficult to remove.

4 Route the Juice Box Pro harness from the tail section towards the engine.

5 Locate the stock injector connectors.

The front cylinder connector is brown and the right rear cylinder connector is grey.

6 Unplug these connectors from the injectors as shown in Figure A.

7 Attach the connectors from the Juice Box Pro to the stock wiring harness and the

injectors as shown in Figure B.

Connect the orange wires from the Juice Box Pro to the front cylinder and stock

brown connector.

Connect the yellow wires from the Juice Box Pro to the right rear cylinder and stock

grey connector.

8 Locate the throttle position sensor (TPS) connector.

The TPS connector is located on the left side of the throttle body.

9 Unplug the connector from the TPS as shown in Figure C.

1 2 3 4

Pas de commentaire

Two-brothers-racing Suzuki SV650 Manuel d'utilisateur Page 3